Tuesday, November 6, 2012
Subaru Impreza WRX Installation Guide
Subaru Impreza WRX Installation Guide table of content:
0. Before You Start
1. Install Air lines & Wire-Harness
2. Install ECU
3. Install Air Storage Tank
4. Install Valve-Block & Air Dryer Unit
5. Install Air Compressor Assembly
6. Connect Wire-harness to Car
7. Install Height Sensors & Linkages
8. Install Air-Struts & Attach Linkages
9. Test System – Calibrate ECU
10. Re-Install Panels, Covers, Shields & Trim Pieces
11. Perform Suspension Alignment
12. Operation the System
13. Troubleshooting
Before you get started to tuning your Subaru Impreza WRX:
• Check shipment – Make certain you have THREE boxes with the following components:
BOX #1 • Two front air strut assemblies
BOX #2 • Two rear air strut assemblies
BOX #3 • The top layer of the package is a box that contains the following items
• The lower level of the box is open and contains the all item.
• Thoroughly read and understand the instructions prior to starting the installation.
• Sections 1 through 6 can be performed wile still maintaining a driveable vehicle. If you need to drive the vehicle prior to completing the installation, make sure to cover all open air lines with tape.
• Sections 7 through 10 will require completion to drive the car.
