Thursday, February 2, 2012
Installation manual Single-frame front bumper Audi A6 C5 HF 7551 4B
1. Remove the original bumper:
Remove all the screws that hold the bumper. Also remove the screws which alloy Panel and remove the bumper bar of the alloy. Delete the alloy from the bumper and install it into the new Hofele-Design of the bumper.
2. location of Hofele-Design front bumper cars:
Place the new bumper on the car, but the plug is not yet latch on.
3. preparation of the bonnet:
Remove the front Grill and the strap rubber for him. Install the front Grill (HF 7052-S4/RS4) in the extension piece.
4. the location of the extension:
Place the tube on the bonnet/hood and repaired with adhesive tape. Align the front Grill, so that neither the slit between the bumper and grill.
5. Screwing the bumper:
After the correct alignment of the bumper and the front Grill can screw the bumper. Therefore go to the bumper and a diameter of 8 mm to the alloy of the two holes with a diameter of 10 mm. Then remove the M8 thread into holes. Using the supplied screws + washers shit in the bumper.
6. the Gluing tube and bonnet/hood:
Mark the correct position of the tube with adhesive tape. Sand on the surface and later to clean it. Then apply a special glue (part of delivery) to the extension piece. Place tube on the bonnet/hood and fix it with tape until the glue is completely dry (at least 24 hours).
