Saturday, February 4, 2012
Installation Instructions 2002-UP Honda CRV Safari Bar Assembly
STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine passenger and driver mount brackets from figure above.
STEP 4. Remove the (16) push type retainers and (2) 6mm bolts from the lower splash shield. Remove plastic splash shield to gain access to mounting locations.
STEP 5. Locate the (4) 14mm holes in the lower radiator support. Attach the mount brackets using the (4) 1/2-13 x 1.00” hex head bolts, (4) 1/2” external-internal tooth lock washer, (4) 1/2” flat washer, (4) 1/2” lock washer, (4) 1/2-14 hex nuts, (2) 5/16-18 x 1.75” hex head bolts, (2) 5/16” lock washer, (2) 5/16” flat washers and (2) 5/16-18 flange lock nuts. Leave loose.
CAUTION: Wheels must be supported to support sub-frame to the unibody to avoid misalignment for re- attachment.
STEP 6. Install mount braces one side at a time. Remove the 14mm under carriage bolt and attach the mount brace using the existing 14mm bolt and supplied (1) 14mm lock washer and (1) 14mm flat washer per side.
STEP 7. Repeat for opposite side.
STEP 8. Temporarily attach Safari Bar using the supplied (2) 1/2-13 x 2.00” hex head bolts, (2) 1/2” lock washer and (2) 1/2” flat washer. Center and level. Hand tighten Safari Bar bolts. Tighten and torque mount brackets bolts only, leave 14mm mount brace bolts hand tight, and remove Safari Bar only.
STEP 9. Cut the plastic splash shield to accommodate the mount brackets and attachment of the Safari Bar. See cutting instructions for guidelines on cutting.
STEP 10. Re-install the splash shield, 6mm bolts and all push type retainers.
STEP 11. Re-attach Safari Bar using 1/2” fasteners previously removed. Center, level and torque fasteners to specifications below.
