Monday, February 6, 2012

Home » » Sintra E49-Opel-English

Sintra E49-Opel-English

Sintra E49-OpelTo read carefully this provision apply to hints. The problem that is described in the installation should be towing by car manufacturer. Assembly instructions 1. Check out the spare wheel. Remove two bolts from the towing eye: one from the left side and one stone. 2. loose standard right angle bar (pos.-5) to the right side of the case (through a hole. A lightning bolt m10 x) using 35 mm (pos. 8). For models without a matching right angle patch level loose bar (pos. 5) on the left side of the case (through a hole. A lightning bolt m10 x) using 35 mm (pos. 8). For models with level adjustment: remove bolt x shown in Figure 2, where the angle of the bar (pos. 5) between the removed Panel only the chassis. Correcting with loose bolt m10 x 35 mm. Chevrolet TRANS sport: as a central section, the bumper cut his segment: width 50 mm, depth 40 mm. cutting out a bumper reinforcement according to figure 3. Towing eye original decomposition. Put the exhaust pin through the hole in the rearmost ø19mm siponi brackets of the problem.

Web site: www.snbimport.com | Filesize: 100 kb
Number of pages: 2
Download E49-Opel Sintra angielska. pdf