Saturday, February 4, 2012
Clymer manual transmission Mazda RX-2, RX-3 9
RX-2 RX-3 and are available with the United Stales 4-speed manual or automatic communication quickly 3. This chapter provides procedures for removing and repairing manual transmission, as well as procedures for testing and tuning. Specifications applications table 1 (end of period).
Manual transmission
Manual transmission clutch transmission consists of a case, the rear extension housing. Figure 1 (next page) shows the case and rear extension. Figure 2 (page 155) displays the offset engine.
Installation/removal
1. disconnect the battery ground cable
2. refer to figure 2, remove the dust boot iever shift. Remove the bolts attaching. Lift off the cover grip plate and shift.
3. Remove starter (Chapter 7).
4. unplug the wires and the neutral switch lamp backup switch (1 and 8, Figure 1).
5. remove the plug performance (Figure 3). Let the oil drain transmission, then clean the plug and install it
6. disconnect the speedometer cable from the left side of the enlargement. Check out the cable.
7. remove the clutch release cylinder. Second eighth chapter.
8. disconnect the exhaust pipe manifold (Chapter five).
9. disconnect the drive shaft, and then insert the difference Tearward out of the broadcast.
Note: transmission oil transmission if not terrible work behind her.
10. place Jack and block of wood underneath the transmission support it,
11. refer to figure 4 (page 156), nuts and remove 2 transmission Assembly Member combination car. Then remove 2 nuts attaching rubber isolated to an Assembly Member
