Wednesday, September 19, 2012
Citroen C5 opening rear window
Repair warning-before the start of the repair will ensure that the switch is working correctly determine operating switch followed by sections 1 and 2 below to open the rear window then remove the grey plastic Castle close in the public relations, peel back the insulation and the checking of the meter for continuity through the solder pads when operating the switch is pressed. If you have a functioning the following correction should switch to repair your window, assuming that the solenoid is defective. 1. remove the lower trim Tuesday after removal of buttons around and then delete 18 4 buttons secure the inside of closing the alcoves. 2. should be able to open a window by the coil (note-I have removed the trim up to photograph the solenoid). External panel housing the high level brake light should now be deleted. It is secured with 2 large flat-head screws, 2 screws and 2 heads of ordinary plastic clips. Torx T30 screws require a little to remove them. Lift the outer panel of the housing with the high level brake light gently. If the plastic clips are not easy to remove the two plastic covers in the curtains. Note that the two torx screws "to hold the curtain Trim displayed are in fact of plastic, ensure the plugs. Gently pull out the "torx" head "and locking plug will come out. Big brown takes the power connector on the heated rear window and also has, in addition, wire (yellow) for the opening of the rear window of the signal. Using the "Scottish castle", or similar, to connect the yellow and black wire in length of 1,5 m.
get
