Friday, February 3, 2012
Repair Manual Engine Overhaul 1994 Mitsubishi Expo LRV
This PDF file contains the ENGINE overhaul 1994 ENGINE Chrysler 2.4 L 4 Cylinder/Eagle/Mitsubishi Corp. information.
Removal
1. remove the radiator's shroud, cooling fan and friction disc is guaranteed. Remove all drive belts and the crankshaft pulleys. Remote
upper timing belt covers and gaskets. Note bolt lengths and location.
Caution: do not rotate the crankshaft counterclockwise (as seen from the timing
belt end of the engine). If the timing belt has to be reused, mark the direction of
rotation before removing.
2. remove the crankshaft sprocket bolt and washer. Rotate the crankshaft clockwise (as viewed from the timing belt
the end of the engine) until cylinder No. 1 is at TDC of the compression stroke. Align the timing mark on the camshaft
sprocket with mark on cylinder head. See Figure 5.
3. Loosen the timing belt skewer adjustment bolt, and move the skewer against the water pump. Tighten the bolt to
secure skewer. Remove the front timing belt and skewer. DO NOT rotate the crankshaft for timing belt
been removed.
4. remove the camshaft sprocket (if necessary). Remove the oil pump sprocket access plug from cylinder block.
See Figure 4. Insert a. 31.5? (8.0 mm) diameter Phillips screwdriver to block left silent shaft.
5. remove the oil pump sprocket nut and remove the sprocket. Remove the front crankshaft sprocket and the flange. Note
the orientation and order of installation for reassembly reference.
6. Remove rear timing belt skewer assembly. Remove rear timing belt. Remove right silent shaft sprocket
with GIF (if necessary). Remove rear crankshaft sprocket with key.
