Thursday, February 2, 2012
Fog Light Installation Instructions on 2003 Honda CR-V
The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” NOTE: These installation instruction show the left fog light begin installed. The same procedure applies to installing the right fog light.
1. Make sure you have the anti-theft code for the radio, write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery. Installing the Fog Light
3. Open the hood. Loosen the battery bracket nut. Remove the radiator cover (seven clips and one bolt).
4. Remove the four clips, four bolts, and two self-tapping screws that fasten the front bumper. Remove the front bumper.
5. Using masking tape, cover the bumper around the fog light opening.
6. Using a utility knife, slowly and carefully cut out the fog light opening. Be sure to cut your lines as straight as possible, and do not damage the bumper. Remove any burrs from the edges of the fog light grille opening with a file.
7. Attach the rubber trim to the edge of the fog light opening.
8. Position the left fog light adjuster on the left fog light, and install one step screw and one 4 x 8 mm washer-screw.
